Troubleshooting

This page describes a few steps that you can follow in order to track a problem with freeDiameter.

Gathering debug messages

If your problem occurs following a reproductible sequence of events, you may get useful information by:

• Compiling the framework with DEBUG support. This is done by selecting for example CMAKE_BUILD_TYPE=Debug during the build configuration (see Installation for more information).
• Running the daemon with a higher level of details in the debug output. This is done by passing one or more -d flags on the command line. The level can be increased up to 10 times (-dddddddddd) but the framework becomes usually unusable after 4 or 5... Anyway, in most cases, -ddd should give enough feedback to get a precise idea of what is going on.

In addition, if you were able to isolate the function or at least source file where the problem is occurring, you can use --dbg_func=<funcname> or --dbg_file=<filename> to get maximum detailed information in this function/file only.

---